Services
Services
The measurement and calibration disciplines available through Detroit CMM Calibration and Repair.
What Is Offered
CMM calibration and repair, CMM programming, and gage calibration for the instruments handed over alongside the machine — scoped to what IATF 16949 audits actually check.
Services Offered
Each discipline below has its own page setting out method, scope and what a request should contain.
- 01
CMM Calibration
Performance verification, geometric adjustment and error-map updates for bridge, gantry and cantilever CMMs.
Open → - 02
CMM Programming
Offline and online part programs across PC-DMIS, Calypso and PolyWorks for body and chassis dimensional layout.
Open → - 03
Gage Calibration
Calipers, micrometers, gage blocks, plug and ring gauges, and surface plates on the same recall schedule as the CMM.
Open →
How Each Job Is Handled
Work is performed under ISO/IEC 17025:2017. Methods, ranges and measurement points are confirmed against the request before work begins, and results are issued on a certificate or report that states the method used, the conditions of measurement and the associated uncertainty.
Coverage across Detroit, MI and the wider Michigan and the Greater Midwest area is listed on the service areas page. The standards, traceability and management arrangements behind the work are set out on the quality system page.
Have a specific item to quote?
Send the item, measurement points, tolerances and required turnaround, and a written quotation is prepared and returned.